A pad sized to exactly what it has to bear, reinforced for the weight on top and based for the shrink-swell clay below, so it holds its place without lifting or settling, whether it sits behind an Irving home or beside a Las Colinas equipment yard.
Credibility comes from how it's built, not from promises. Here's the order of operations on every concrete pads & slabs job.
We moisture-condition, compact, and grade the base over Blackland clay so the load spreads evenly and the pad doesn't ride up or settle as the soil drinks in and gives back water beneath it, a swing the low ground near the river runs hard.
The thickness follows whatever sits on the pad. A backyard shed footprint and a campus equipment pad under serious weight are nowhere near the same pour.
Reinforcement is tuned to the job, mesh under light pads and a stepped-up rebar grid for heavy loads and for spanning the movement our expansive ground works into every slab.
Under an enclosed or finished pad we roll out a vapor barrier so dampness in the ground stays below and can't wick up into the slab.
We place a well-proportioned mix, saw the control joints, and run a cure schedule that keeps the afternoon heat from pulling strength back out of the top.
Most contractors vanish after the deposit. We pick up the phone, show up when we say, and stand behind the work after the truck leaves. The follow-through is the difference.
A foreman we know runs your job and a vetted crew does the work, managed by Lucky's, one company accountable from the first call to the final walkthrough.
COI and lien waivers on file before we break ground. The documentation that lets commercial clients pay and gives homeowners peace of mind.
Prepped subgrade, reinforced and mixed to spec for the job, and proper curing. We build credibility through the process, not promises. On concrete pads & slabs, that starts with base prep on clay.
In North Texas a pad takes its price from the load and the soil under it: reinforcement matched to the use, a compacted base over expansive clay, drainage minded on lower ground, and a cure held against the summer sun. As a starting range, most pads and slabs run about $7 to $13 per square foot, depending on thickness and whether a vapor barrier is called for. We size and quote each one against the weight it has to stand under.
The load sets it. A shed pad asks a lot less than a garage, a shop floor, or a campus equipment pad carrying real weight, so we match the thickness and the steel to your actual use and to the expansive clay underneath.
Yes. Both are heavy, point-loaded uses, so we increase the thickness and the steel. A hot tub in particular wants a level, settled base that won't tip or sink as the clay works, so the groundwork carries as much weight as the slab does. Give us the equipment list and we build the pad around it.
For enclosed or finished slabs, usually yes; the barrier keeps ground dampness from creeping up through the concrete. We make that call job by job, based on what the slab is for.
Some do, depending on the size, the spot, and the purpose, and a slab inside the Trinity floodplain can carry extra review on top of that. We flag when a permit looks likely so it is squared away before the pour, not after.
Concrete keeps gaining strength after the surface looks set. We give you a clear date to put equipment on your specific pour, with the week's heat folded in.
You'll hear back from a real person, usually the same day. No call center, no runaround, no chasing us down.
Booking up fast this season. Or call (972) 318-9464